This page contains Misc. Parts, stock heater nipple, dipstick parts, polymer dist. gear, oil restrictors, Race and Street starters
This is a stock replacement heater nipple for stock cast iron heads. Has the old style coil heat spring inside. This is a perfect replacement part. $ 25.00
Here is the replacement dipstick for your stock Pontiac engine. This is a
non AC dipstick. $ 12.00
Here is the replacement upper
dipstick tube that presses into the block from the crankcase side. This is a
stainless steel piece that will last a lot longer then the stock piece.
$ 26.00
This stock replacement lower dipstick is made from stainless steel. Designed to
fit with the stock windage tray. $ 20.00
This tube is just like the other lower tube other then it has the strap
welded to it to bolt to the center main cap. $ 20.00
This is BOP's Polymer distributor gear designed for billet roller cams. If your
planning on running a solid roller or hyd roller cam you will need one of these
or a bronze dist. gear. The stock gears will not hold up against the billet cam
core. I recommend these for street setups. This one if for a stock distributor
with a .491 shaft diameter. $ 125.00
This is for an MSD .500 diameter shaft. $ 125.00
These oil restrictors come with a .025 hole size. Once installed they will help
keep your oil and pressure where you need it in the bottom end of the engine.
Ask for custom hole sizes. $ 30.00 set
call for the hole size you need
RACE STARTER
This starter is one of the best I've seen. It has 200 ft.lbs rating with a 4.41 gear reduction. It only weighs 8.5 lbs. It comes with a heat soak resistant housing and an aluminum billet mounting surface. This starter is for 12 to 1 compression engines and higher.
$215.00
STREET STARTER
This is Power Masters street starter. Designed for 12 to 1 and lower compression engines. It's rated at 180 ft.lbs and has a multi positioning mounting surface.
$180.00