mandrel drive
custom parts
water pumps
intake manifolds
misc.parts
| |
External engine parts
page. This
page contains KRE oil filter housing, KRE remote oil filter plate, KRE water
cross over, KRE timing cover, Tip alternator relocation kit, TIP
Round port header flanges
|
Check out this stock replacement
aluminum Pontiac oil filter housing made by Kauffman Racing Equipment.
This Pontiac oil filter housing is designed for the stock oil filter and
has the angle to pull the filter closer to the block for header
clearance. It is made from 356-T6 aluminum for strength an will fit the
MR-1 and stock Pontiac blocks. This oil filter housing is drilled
and tapped to accommodate an oil pressure sending unit / gauge.
There is no oil bypass provision.
$55.00
Setup for remote filtering of oil with this
KRE Remote Oil Filter Housing Plate. It is CNC machined out of 6061T-6
aluminum and has been tapped with a 1/2" pipe tap for fitting
aluminum AN fittings or hydraulic hose.
$35.00
KRE water cross over
$60.00
This is the new KRE aluminum Pontiac timing cover!
This Pontiac timing cover is made by precision sand casting 356-T6
aluminum. The timing cover comes with the following
features:
-
Seal installed
-
Can be ordered with heater nipple drilled (upon
request - Please specify when ordering)
-
Has 0, 6, and 12 degree timing marks like the
original 1969 Pontiac timing cover
-
Fully 5 axis CNC machined
-
Accepts ALL standard Pontiac parts from 1969 and
up
-
| - fuel pumps and block offs |
| - water pump sleeves |
| - water pumps |
| - water pump divider plates |
| |
-
Intake manifold crossover hole is sized for 1/8
pipe tap should you want to block it off
-
Cast and machined in the U.S.A
-
$175.00
-
Pontiac
Alternator relocation kit
-
crank
mandrel drive system. The system is extremely versatile
and flexible giving the installer many options during installation.
The alternator's drive pulley location can be adjusted simply by
trimming the spacers. The bracket was designed to fit
most Pontiac heads as well as most aftermarket heads (Kauffman D
Port, Kauffman High Port, Edelbrock, etc.) The mounting bracket is
made from stainless steel. Bolts and washers are also
stainless steel.
$44.99
These 2.125" Round Port (RAIV) exhaust
flanges are CNC cut from 3/8" thick steel.
Great start for those making a set of 2 1/8" headers for your
High Port combinations! Designed for all round port heads like
the KRE High Port, Edelbrock and Ram Air II & IV and DCI Tiger
Head
$60.00 Pair
TIP Pontiac Crank
Mandrel
$160.00
|
|
